06 Jun Polaris 180, 280 Not Moving (Changing the Wheel) 2017-06-06T12:13:47+00:00 By Polaris 280 Repairs Changing, Moving, Polaris, Wheel 5 Comments RELATED PRODUCTS: Share this post FacebookTwitterLinkedInGoogle +Email Author Comments (5) Swimming Pool Tips, Reviews & How To -MrDgvb1 Log in to Reply Ha ha. Glad to hear you got the problem fixed. June 6, 2017 at 12:18 pm Dan Kearney Log in to Reply I finally got out all the pcs for both bearings and then was able to "rebuild " each bearing and replace them (until I get 2 new ones). Thanks for your reply and the videos. I am now planning to go into business as a Polaris repairman after taking your "class"……:-) i am much more knowledgable now. June 6, 2017 at 12:38 pm Swimming Pool Tips, Reviews & How To -MrDgvb1 Log in to Reply You can get the broken piece out with a screwdriver from the opposite side of where it is stuck in. Just put the tip of the screwdriver on it and hit the screwdriver with a rubber mallet. It should pop right out June 6, 2017 at 1:15 pm Swimming Pool Tips, Reviews & How To -MrDgvb1 Log in to Reply Yes. Just replace both sets of bearings. Once they fall apart that is the end for them. It is the same bearings for the other 3 wheels: part #C60. They are like $5.00 each online. Hope that helps. June 6, 2017 at 1:33 pm Dan Kearney Log in to Reply Can You contact me w/ a pm to discuss changing out the smaller "drive wheel" on the other side of the cleaner. I was checking the bearings on it and a plastic piece theta kept the individual bearings separate came off from the inside bearing, leaving the steel bearings to roll around and next to each other. So far I am unable to put this piece back into the wheel. Should I attempt to remove the rest of that bearing (as well as the second one on the other side) and replace them? June 6, 2017 at 2:03 pm Leave a Reply Cancel replyYou must be logged in to post a comment.